Liberal tolerances allow a faster rate of production and lower cost. The “standard” length tolerances shown in the chart below normally permit a saving over “close” tolerances. Length Tolerances closer than those shown below can be supplied at a higher cost upon (1) reviewing your specific requirements and (2) mutual agreement regarding the method of inspection. Contact us to discuss your specific requirement.
| Length in Feet | Aircraft Assys. | Up to 5/16″Cable | Above 5/16″Cable |
|---|---|---|---|
| 0-6 | .063″ | .125″ | .250″ |
| Over 6-10 | .094″ | .187″ | .375″ |
| Over 10-20 | .125″ | .250″ | .500″ |
| Over 20-40 | .187″ | .375″ | .750″ |
| Over 40-60 | .375″ | .500″ | 1.00″ |
| Over 60-80 | .438″ | .875″ | 1.75″ |
| Over 80-100 | .500″ | 1.00″ | 2.00″ |
| >100 | .563″ | 1%* | 2%* |
