Standard Length Tolerances for Cable Assemblies & Cut Length Cable
Liberal tolerances allow a faster rate of production and lower cost. The “standard” length tolerances shown in the chart below normally permit a saving over “close” tolerances. Length Tolerances closer than those shown below can be supplied at a higher cost upon (1) reviewing your specific requirements and (2) mutual agreement regarding the method of inspection. Kontakt to discuss your specific requirement.
TOLERANCES IN INCHES, PLUS OR MINUS
Length in Feet | Aircraft Assys. | Up to 5/16″Kabel | Above 5/16″Kabel |
0-6 | .063″ | .125″ | .250″ |
Over 6-10 | .094″ | .187″ | .375″ |
Over 10-20 | .125″ | .250″ | .500″ |
Over 20-40 | .187″ | .375″ | .750″ |
Over 40-60 | .375″ | .500″ | 1.00″ |
Over 60-80 | .438″ | .875″ | 1.75″ |
Over 80-100 | .500″ | 1.00″ | 2.00″ |
>100 | .563″ | 1%* | 2%* |